Concrete stamps are available in many sizes. Also shapes and patterns ranging from faux stones to capturing prints to celestial images. To make diy stamped concrete patio, starting with prepare area for a concrete pour by measuring, marking, excavation, adding crushed stone and wire mesh and finally concrete. Next, wait the top layer of moisture is no longer visible on the surface of the concrete that depends on the outdoor temperature. And also weather conditions and can vary anywhere from 15 minutes to one hours.
After that, continue diy stamped concrete patio project with place the stamp on the wet concrete. And press it for half an inch to 1 inch depending on the type of stamp. Stamps that come as metal plates with two vertical handles sink into the wet concrete under compulsion. Grab the vertical handle, lift the stamp, and put it on the wet concrete. Press, lift and move the stamp next to the embossed design and repeat. Are you using a large scroll that rolls over a concrete surface and leaves impressions as it rolls? So, the scroll rolls in a continuous forward line.
12 Photos Gallery of: Step By Step Guide Of Diy Stamped Concrete Patio
After reaching the end of the concrete surface, lift the roller and start rolling the side of the first line. If you use a stamp food, place the stamped mat on the wet concrete. Tamp the mat with a hand-held manipulate with equal force all over the mat. Then lift the mat, place it next to the first stamped area and repeat. If you use small hand-held stamps, primarily for borders and accents, place the stamp on the wet concrete. Press down to create and impress, lift and repeat. And the diy stamped concrete patio project was done.